E-mail me
Fuselage Covering of my Rans S6S
Final assembly & engine install
8-26-06
8.0 hrs
|
E-mail me
|
Fuselage Covering of my Rans S6S
|
||
|
Final assembly & engine install
|
|||
|
8-26-06 |
Finished prepping fuselage for covering. bolted 1X4's to firewall for supports to rotate fuselage. Covered bottom of fuselage and tightened to 250 degrees. |
8.0 hrs |
|
|
|
|||
| 8-30-06 | Covered right side of fuselage. Tighten to 250 degrees. | 3.5 hrs | |
|
|
|||
| 8-31-06 | Covered left side | 3.0 hrs | |
| 9-1-06 | Ironed down edges and checked fabric | 2.0 hrs | |
| 9-3-06 | Taped sides and top. | 9.0 hrs | |
| 9-4-06 | More taping. | 1.5 hrs | |
| 9-5-06 | Moe taping and patches. | 4.0 hrs | |
| 9-6-06 | Double checked edges applied two foam brush coats of cecofil to bottom and sides. | 3.5 hrs | |
| 9-7-06 | Applied two foam brush coats of cecofil to top. Began taping off preparing for spraying. | 2.5 hrs | |
| 9-8-06 | finish taping and sanding | 2.5 hrs | |
| 9-9-06 | Spray 3 more coats of cecofil and begin sanding. | 6.0 hrs | |
| 9-10-06 | Finish sanding cecofil. Applied 5 coats of white. Not happy with this paint tries to set up in gun and you cannot keep it in suspension ie: it keeps separating and starts spraying chunky. sanded rough texture this sh** looks like splatter paint. It didn't do good on the wings but I thought it was something I did. I have sprayed Dupont Starthane, Durathane, ChromaOne, ICI's Urethanes and the PPG urethanes and I have never had anything like this. I'll not use Stewart Systems paint again. Their cecofil is fine they just don't have a good paint. Taped off and painted blue. Needs to be redone. | 11.0 hrs | |
| 9-11-06 | Repaint Blue | 2.0 hrs | |
|
|
|||
| 9-12-06 | Installed gear. Turned fuse over. Reinstalled floorboard. | 6.0 hrs | |
|
|
|
||
|
|
|||